Most rooms in the house are equipped with windows in a frame, and all of them feature at least one edge at which the wall meets the ceiling. Imagine if these areas had no detail at all. They would not only appear austere, but they would not look right either. The reason for this is because nearly everywhere you find windows and ceiling edges, you also find cornice. Cornice boards not only add structure to the room, they add aesthetic value. Cornices are meant to cover up fasteners and brackets, and following is some advice on cornice installation.
Begin the process by locating the studs in the walls. You may either rap lightly with your knuckles or utilize a stud finder to do so. Using the weight and thickness of the cornice board, you can decide to attach it to drywall by using anchors if it is light, or you may want to fasten it to the studs if it seems too heavy for anchors. With a pencil, mark the studs in order to later fasten the cornice to the correct spot.
Next, figure out the length of the wall or window that is to be adorned with the cornice. With windows, hold the board up to the opening and center it. In this case, the top edge of the board will be a little above the opening, and the bottom edge will slightly cover the top of the window opening. Once the board has been centered using a tape measure to ensure accuracy, you should mark the spot where the board will be placed.
Next, take the L-brackets and situate them so they appear upside down. You will need to place at least two on each side of the window or length of ceiling, making a place where the interior of the cornice can be placed. If the board is somewhat heavy, more brackets should be utilized. Mark the location where the pilot holes will be drilled. Drill them and insert wall anchors. Ensuring that they are level, attach the brackets to the wall.
Now that the brackets are attached, place the cornice over them and mark the interior of the board where the pilot holes will be. Here, you will need to ensure that the board and brackets are level and that they can handle the cornice. Only drill partially into the interior of the cornice where you made your marks and set it on the brackets Screw the board in place, but be sure that you do not over tighten the fasteners. Otherwise, you will puncture through the cornice. The cornice is now installed, and your room is livelier because of it.
Find out more – Cornice
Related posts:
- Fixing Drafty Windows — Step By Step
- How Sealing a Window Can Help Contain Your World
- Some Benefits Of Window Tinting For Your House
- A Quick Explanation Of How To Repair Rot And Decay On Wooden Windows
- Cooling Your Home With Sash Windows Today
- Basics About Replacement Basement Window
- Want to Know the Right Way to Install Windows?
- Introduction To False Ceiling
- Casting Attention On Versatile Sash Windows And Today’s Homes
- How to Successfully Add, Remove or Move a Window or Door
Tags: diy, Home, home improvement, home repair, Interior design